|
Post by eddy99 on Sept 15, 2019 8:50:20 GMT
I have made plenty of these and the 3 function ones but on the 8 function there seems to be a glitch. If power is cut to decoder with all 8 outputs enabled then powered back up not all outputs are enabled. If F5 is switched on-off all functions are resumed. Has anyone had this problem and found a work around ?
Thanks Eddy
|
|
|
Post by Paul Harman on Sept 15, 2019 22:35:09 GMT
I think that you will need to upgrade to V3.6 of the Lenz firmware in your command station. A workaround may be to put a switch in the track feed and only turn the switch on after you have powered up the command station to block the reset packet.
|
|
|
Post by eddy99 on Sept 16, 2019 8:22:25 GMT
Thanks Paul. Will try the switch first as I have looked around and the 3.6 upgrade chips seem to be hard to get.
Thanks Eddy
|
|