|
Post by ttrians on Dec 21, 2016 5:34:56 GMT
Hi guys
I have made a decoder and tried to connect with NCE command station using JMRI, however, which manufacturer should we choose in the list because the Decoder Pro couldnt detect any decoders now. I have also tried with the load (only 50ohms resistor without motor), but it does not work still. Is it possible to connect using JMRI, or if not, should I send command directly to the station? Does any body have the idea about it? Thanks!!
|
|
|
Post by Paul Harman on Dec 23, 2016 19:12:36 GMT
Ttrains
Have you tested the decoder and verified that it is working? Put a bulb in place of the motor if you don't have a motor.
The DIY Decoders do not have a manufacturer ID so you have to manually select the decoder. The DIY Motor decoder is just a basic decoder with short address so just use the basic settings. The other DIY decoders do have definitions in JMRI but still need to be manually selected.
|
|