kone
New Member
Posts: 2
|
Post by kone on Jun 24, 2014 0:28:46 GMT
I armed the Motor Decoder, and it work very well Change some CV values to suit different types of motors, but I have some problems, when I read the CVs, only read cv1=0 , cv2 =1, cv3 = 2 ...... cv3=4 … etc which are the location in the EPROM (I use a Digitrax PR-3 and a home made programmer reader with Prolok and the same result
|
|
suzie
Keen DIYer
Posts: 30
|
Post by suzie on Jun 26, 2014 1:06:00 GMT
You might like to try a different mode, register will work for the lower CVs but try Direct and Paged to see if there is a difference.
|
|
kone
New Member
Posts: 2
|
Post by kone on Jun 29, 2014 10:04:32 GMT
I have tried different ways and always with the same result even DecoderPro3
|
|
suzie
Keen DIYer
Posts: 30
|
Post by suzie on Jun 30, 2014 12:55:42 GMT
It will probably be best to just keep a note of the values. DecoderPro should be able to keep the current settings in a roster entry so that you do not have to re-read them.
|
|