|
PCB
Jun 26, 2012 18:04:58 GMT
Post by Gareth on Jun 26, 2012 18:04:58 GMT
Hi
I know there was some discussion some time ago regarding the pros & cons of developing a PCB for the "Decoder" and it seemed that the strip board was still the favorite due to cost and adaptability. However I see that on the motor decoder web page there is a picture of a decoder connected to a motor using a PCB.
I will be making some other PCBs in the near future for another project and if the pcb design is available could I get a copy please?
Gareth
|
|
|
PCB
Jun 27, 2012 7:32:02 GMT
Post by Paul Harman on Jun 27, 2012 7:32:02 GMT
The picture is of an '0' gauge prototype decoder that someone made with dual op-amps for 3.2A power output. I think it has a few errors underneath and I do not know if the design was ever finished.
I think that you will be as well to produce your own layout that suits your needs and I will be happy to add it to the website.
|
|
|
PCB
Jun 27, 2012 17:13:45 GMT
Post by Gareth on Jun 27, 2012 17:13:45 GMT
Hi Paul
Noted and thanks.
Gareth
|
|