|
|
Post by murphyfp on Feb 18, 2014 20:07:41 GMT
I have done a Vero Board layout for a 10 Function output board
Its show the component layout and link layout
Also It shows where to cut the underside of the board.
I have tried to lay it out so it is easy to follow and easy to build.
It could be use to drive lights in buildings ect ect
Have fun
|
|
|
|
Post by murphyfp on Feb 18, 2014 20:12:57 GMT
|
|
|
|
Post by Paul Harman on Feb 19, 2014 0:05:56 GMT
It is a nice start, and keeps all the components flat. There are a couple of problems that need ironing out though.
1. There is a 10K resistor missing (should go from track 1 to track 5 left of the regulator). A stationary decoder will probably work OK without it!
2. Pin 4 of the PIC is an input (it is the same on all low pin count PICs).
3. With the published firmware there are only eight separate outputs, pins 5 and 11 have the same function (with the exception that pin5 can be flickering while pin11 is always steady)
|
|
|
|
Post by murphyfp on Feb 19, 2014 11:50:36 GMT
Hi Paul
It is intended for a 10 output function only stationary decoder.
I Intend to make all outputs output mode,
Apart from the two for the DCC Data Inputs.
I did a 8 Output that works fine with F1 - F8 remapped and the Leds run Led 1 to Led 8 with no F0 input.
I intend to change the code to use the two spare outputs for F9 and F10.
I will send you the code when I have it done.
Pleased you like the Vero layout
|
|
